Weld

Top view of weld seam

These commands are used for welds based on a selectable contour (lines, polylines, circles or bends) or linear via two points. The alignment of the weld is variable.

Weld: at axis, left or right:

Enter a width and the weld is inserted into the drawing as a group.

Weld in a sectional view

Command: "Hollow moulding seam"

Command: "Arch seam"

Command: "Flat seam"

These commands are used for creating sectional views of welds in different layouts via three points.

The first two points are to define the location of the weld. The third point is to define the position of the root run.

Weld symbols

This dialog box is used to define the design of the symbols.

To alter a symbol use the function "Alter weld symbol" or double-click the symbol.