Line

 Top  Previous  Next

Toolbar: SYSCAD Draw2 -> SYSFLY line -> Line 0.18 Line 0.25 Line 0.35 Line 0.50 Line 0.70 Line 1.00 Line - - - Line -.-.- Centre line with overhang Centre line with overhang Aluminium line Steel line Stainless steel line Plastic line Wood line

Settings and defaults under: SYSCAD-Variable / List

Ribbon: SYSCAD Draw -> Line -> Line 0.18 Line 0.25 Line 0.35 Line 0.50 Line 0.70 Line 1.00 Line - - - Line -.-.- Centre line with overhang Centre line with overhang Aluminium line Steel line Stainless steel line Plastic line Wood line

Settings and defaults under: SYSCAD-Variable / Attachment-Details

 

Command: "Line 0.18" Line 0.18 Starts the line command and draws on layer UMRISS018. (Def.: SYSCAD variable -> List -> Layer -> Object layer 1)

Command: "Line 0.25" Line 0.25 Starts the line command and draws on layer UMRISS025. (Def.: SYSCAD variable -> List -> Layer -> Object layer 2)

Command: "Line 0.35" Line 0.35 Starts the line command and draws on layer UMRISS035. (Def.: SYSCAD variable -> List -> Layer -> Object layer 3)

Command: "Line 0.50" Line 0.50 Starts the line command and draws on layer UMRISS05. (Def.: SYSCAD variable -> List -> Layer -> Object layer 4)

Command: "Line 0.70" Line 0.70 Starts the line command and draws on layer UMRISS07. (Def.: SYSCAD variable -> List -> Layer -> Object layer 5)

Command: "Line 1.00" Line 1.00 Starts the line command and draws on layer UMRISS10. (Def.: SYSCAD variable -> List -> Layer -> Object layer 6)

Command: "Line - -" Line - - Starts the line command and draws on the layer VERDECKT. (Def.: SYSCAD variable -> List -> Layer -> VERDECKT).

Command: "Line -.-.-" Line -.-.- Starts the line command and draws on the MITTE layer. (Def.: SYSCAD variable -> List -> Layer -> MITTE).

Command: "Extended centerline". Centre line with overhang Draws a centre line on the layer MITTE, this centre line is  extended by a  value defined in the SYSCAD-Variable / List / Miscellaneous / Prolongation of midline.

Command: "Extended center line of a circle". Centre line with overhang Draws a centre line in a selected object on the layer MITTE, this centre line is extended by a value defined in the SYSCAD-Variable / List / Miscellaneous / Prolongation of midline.

Command: "Line Aluminium" Line Aluminium Starts the line command with the layer defined in the SYSCAD-Variable / Attachment-Details / Aluminium (e.g. layer SYS_AL_CONT).

Command: "Line Steel" Line Steel Starts the line command with the layer defined in the SYSCAD-Variable / Attachment-Details / Steel (e.g. layer SYS_ST_CONT).

Command: "Stainless Steel Line" Line Stainless Steel Starts the line command with the layer defined in the SYSCAD-Variable / Attachment-Details / Stainless steel (e.g. layer SYS_ST_CONT).

Command: "Line Plastic" Line Plastic Starts the line command with the layer defined in the SYSCAD-Variable / Attachment-Details / PVC profile (e.g. layer KPROFIL).

Command: "Line Wood" Line Wood Starts the line command with the layer defined in the SYSCAD-Variable / Attachment-Details / wood (e.g. layer SYS_WO_CONT).