Draw glazing bead in filling

 Top  Previous  Next

 

Toolbar: SYSCAD Generating sections -> SYSFLY View -> Glasleisten Gehrung

 

Ribbon: SYSCAD Gener. Sections -> Cut List -> Glasleisten Gehrung

 

 

 

With this command you could draw glazing beads in the fillings as an extra contour.

 

- Draw glazing bead in filling (mitre joint)  Draw glazing bead in filling (mitre joint)

- Draw glazing bead in filling (vertical cont.) Draw glazing bead in filling (vertical cont.)

- Draw glazing bead in filling (horizontal cont.)  Draw glazing bead in filling (horizontal cont.)

 

Command:

Face width ?

Face width <13.2>: Type in the face width of your glazing bead

Layer <WHC_INSERT>: Choose the layer

Profile number <B8773>: Type in the article number of your glazing bead

 

1. Corner (bottom left)

or select point in closed contour   Click into your filling

Block name = GLASLEISTEN_1

 

The contour of your glazing bead will be drawn into your elevation. Note: If you change the filling information - the block will not be updated.