Dimension complete

This command is used to completely dimension your elevation. Glass dimensions, outer vent dimensions, face widths of frame and T/M-Profiles and the total width are shown. The mode of operation is similar to the centre line dimension.

Command:

Dimensioning face width from point:(P1)

to point: (P2)

horizontal dimensioning

Origin of extension line : (P3)

Dimension line location : (P4)

The dimension style for the elevation can be defined in the SYSCAD-Variable / Dimension / Dimension / View:

In case you draw your elevation on scale of 1:1 and display it 1:10 in general, it is advisable to assign the style ANSICHT1_10, defined in the prototype drawing SYSCAD.DWT, to the variable DIMENSION STYLE ELEVATION. All dimensions of face widths are drawn at the pre-defined layer and in style ANSICHT1_10.