SYSCAD - CAD for metal construction Start  back  next

Centre line grid

 Generating sections > Centre line grid

Toolbar: SYSCAD Generating sections -> Hilfsraster

 

Ribbon: SYSCAD Gener. Sections -> Centre Line Grid -> Hilfsraster

 

 

Generating grid lines as subsidiary lines for the programs FRAME and T/M-PROFILE or for the conversion with the program Ansicht aus Hilfsraster "Elevation from centre line grid".

Enter all necessary data for the program Hilfsraster erzeugen "Determine Centre Line Grid" into the dialog box shown below.

This example should show you the input logic.

kap5_5

We have divided the total width of 2000 into four parts. The width of the first part is 400, of the second part 300 . The third and the fourth part are not stated, therefore SYSCAD® apportions the rest evenly - 650 in width each.

The first and the third part are defined for the heights. The second part is calculated by the program.

If there are no information about the partition, the grid is apportioned evenly.

For subsequent alterations activate the function "Alter measure" MASS ÄNDERN and select the desired dimension. Always proceed from the left to the right and from the bottom to the top!