Copy filling

 Top  Previous  Next

Toolbar: SYSCAD Generating sections -> SYSFLY-Filling -> Füllung kopieren

 

Ribbon: SYSCAD Gener. Sections -> Filling -> Füllung kopieren

 

 

This command is used to copy fillings. Call the command and click on an element of the filling to be copied (for example on the fitting symbol).

Afterwards click into the opening to be filled. The properties of the original filling are shown. You can modify the properties or just take it you over with OK.

The fitting check is performed. In case the dimensions of the opening of the copy does not correspond with the master, the fitting must be chosen again.