Pressure plate / face cap

With FACADE series you have to define the pressure plates and face caps after the definition of the fillings.

Example:

Call the program "Pressure plates / face caps" and select all transom profiles with a selection window from the left to the right. Windows and mounting frames are ignored by the program.

Subsequently, select all four mullion profiles with a selection window from the right to the left.

Alternative:

You can select the profiles as described here in the video:

To adapt or alter the pressure plates and face caps please use the commands listed in the following topics.

In case there are several profile variations in the elevation, e.g. as with RAICO standard transoms and sill transoms, it is necessary to select the pressure plates and face caps separately for each variation. SYSCAD can only assign pressure plates and face caps to one profile variation at a time. The assigned profiles are displayed green. The non-assigned profiles are displayed with red interrupted lines.

Using the command "Delete Press. Plate / Face Cap" the assignments are deleted again.