Rename block / rename all blocks

Command: "Single blocks are renamed" You can rename blocks in your drawing. You must specify the new block name for each block in a dialogue box.

Command: "Rename all blocks". You can have all blocks in your drawing renamed automatically.

All blocks in the drawing are renamed to Blockname_DayMonthYear_HourMinuteSecond.

The following use case is conceivable: You want to continue working with SYSCAD profile blocks in a transfer drawing from a calculation programme. For example, you want to use the possibilities of automatic glazing, combination or section generation. If the blocks required by SYSCAD are still present in the original position and with the original insertion point of the profile system supplier as internal blocks in the drawing, SYSCAD will use these blocks for glazing etc. The result will not look as expected. The result will not look as expected. Therefore, please use this command "Rename block" before inserting the blocks from the SYSCAD library. Then the correct SYSCAD blocks from the SYSCAD profile system directory will be inserted in any case, because the already existing ones now have a different block name due to the addition _DayMonthYear_HourMinuteSecond.